GSI Forum: Installation and Compilation » Problem with run

Home » R3BRoot » Installation and Compilation » Problem with run_sim.C after new installation (Problem with run_sim.C after new installation)

Show: Today's Messages :: Polls :: Message Navigator

Problem with run_sim.C after new installation [message #23719]

Wed, 13 March 2019 13:44

C. A. Douma
Messages: 88
Registered: September 2015
Location: Groningen

continuous participant

From: *kvi-cart.rug.nl

Dear all,

I have just done a new installation of FairSoft, FairRoot and R3BRoot after a system crash.
Installation and compilation all went OK without errors (I used dev branches everywhere).

However, when I try to run a simulation with run_sim.C, I get problems.
The full output log is attached. Can anyone help me?

Christiaan Douma.

Attachment: Log.txt
(Size: 990.53KB, Downloaded 3038 times)

Report message to a moderator

[Message index]

		Problem with run_sim.C after new installation By: C. A. Douma on Wed, 13 March 2019 13:44
		Re: Problem with run_sim.C after new installation By: Dmytro Kresan on Thu, 14 March 2019 09:55
		Re: Problem with run_sim.C after new installation By: Dmytro Kresan on Thu, 14 March 2019 17:33
		Re: Problem with run_sim.C after new installation By: C. A. Douma on Wed, 27 March 2019 13:15

Previous Topic:	FairSoft compilation error
Next Topic:	Error in R3BRoot CMakeLists.txt dev-branch

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jul 18 08:03:13 CEST 2025

Total time taken to generate the page: 0.00800 seconds