GSI Forum: Event Generators » DPM wrong coulomb/hadron elastic ratio

Home » PANDA » PandaRoot » Event Generators » DPM wrong coulomb/hadron elastic ratio

Show: Today's Messages :: Polls :: Message Navigator

DPM wrong coulomb/hadron elastic ratio [message #13980]

Wed, 19 September 2012 17:49

Stefan Pflueger
Messages: 99
Registered: February 2012

continuous participant

From: *kph.uni-mainz.de

Hello again,

while digging through the DPM code to resolve my disagreements for my studies regarding the luminosity monitor, I found yet another problem with the DPM generator. The numeric integral (riemann integral) used to calculate the coulomb part the elastic cross section is very imprecise, which then causes a wrong ratio between the coulomb and hadron cross section. The imprecision arises from the rather large stepsize for the integral compared to the dimension of the peak region of the coulomb diff. cross section. Instead of using the trapezoidal rule it now uses the simpson rule and the number of divisions has been increased. Additionally I distributed the intervals with 1/t to get higher precision in the low t range (only for the coulomb cross section). This gives the necessary precision for all of our beam energies.

I already contacted Aida Galoyan and passed her the relevant information.

Best regards,

Stefan

[Updated on: Fri, 05 October 2012 10:38]

Report message to a moderator

Previous Topic:	DPM weird t spectrum (random problem)
Next Topic:	New pbarpSystem and pbardSystem implementations

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 01 17:13:24 CEST 2025

Total time taken to generate the page: 0.00927 seconds