Home » PANDA » PandaRoot » General » Tasks in Simulation session
Tasks in Simulation session [message #7644] |
Wed, 17 December 2008 10:48  |
Mohammad Al-Turany
Messages: 518 Registered: April 2004 Location: GSI, Germany
|
first-grade participant |
From: *gsi.de
|
|
Hallo,
I added a macro to the /macro/emc (sim_hit_emc.C) showing how to add tasks with parameters to a simulation session, this macro will analyze the EmcPoint directly after simulation and write the EmcHit to the tree. the only change in the Task needed to do this is in the SetParContainers() method one should use the base class CbmRun and not the CbmRunAna, (which will work also for an analysis session).
// Get run and runtime database
CbmRun* run = CbmRun::Instance();
CbmRuntimeDb* db = run->GetRuntimeDb();
For this example both points and hits are saved to the file, so may be one should implement a method to switch off writing the points to the file, or an extra argument to the detector constructor! technically one need only to switch off saving to file in the register call, i.e:
CbmRootManager::Instance()->Register("EmcPoint","Emc", fEmcCollection, kFALSE);
regards
Mohammad
|
|
|
|
Re: Tasks in Simulation session [message #7802 is a reply to message #7644] |
Mon, 02 February 2009 21:39  |
Johan Messchendorp
Messages: 693 Registered: April 2007 Location: University of Groningen
|
first-grade participant |
 From: *xs4all.nl
|
|
Dear all,
I modified various "SetParContainers()" pieces of code throughout the complete PandaRoot trunk (rev 4468), following the earlier thread by Mohammad. I compiled, tested randomly and successfully some example macros. If you encounter any problems, let me know.
Johan
[Updated on: Mon, 02 February 2009 22:43] Report message to a moderator
|
|
|
Goto Forum:
Current Time: Thu Aug 14 04:06:56 CEST 2025
Total time taken to generate the page: 0.00398 seconds
|