GSI Forum: General » Moving the Geometry from data file to the parameters

Home » CBM » CBMROOT » General » Moving the Geometry from data file to the parameters

Show: Today's Messages :: Polls :: Message Navigator

Moving the Geometry from data file to the parameters [message #9443]

Wed, 23 September 2009 12:33

Mohammad Al-Turany
Messages: 518
Registered: April 2004
Location: GSI, Germany

first-grade participant

From: *gsi.de

Hello,

The geometry is moved from the data files to the parameter file, this make the fRun->LoadGeomerty() method obsolete, and requires loading the parameters wherever the geometry is needed. usually this is the case for digi and reco macro.

please test it and let me know.

Mohammad

Report message to a moderator

[Message index]

		Moving the Geometry from data file to the parameters By: Mohammad Al-Turany on Wed, 23 September 2009 12:33
		Re: Moving the Geometry from data file to the parameters By: Elena Litvinenko on Fri, 23 October 2009 16:21
		Re: Moving the Geometry from data file to the parameters By: Mohammad Al-Turany on Mon, 26 October 2009 09:09
		Re: Moving the Geometry from data file to the parameters By: Elena Litvinenko on Mon, 26 October 2009 09:27
		Re: Moving the Geometry from data file to the parameters By: Arun Prakash on Mon, 26 October 2009 11:30
		Re: Moving the Geometry from data file to the parameters By: Arun Prakash on Mon, 26 October 2009 11:32
		Re: Moving the Geometry from data file to the parameters By: Mohammad Al-Turany on Mon, 26 October 2009 21:48

Previous Topic:	Control of Cuts for Geant4 in CBMRoot
Next Topic:	CBMROOT release DEC09

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue May 19 11:17:02 CEST 2026

Total time taken to generate the page: 0.00717 seconds