GSI Forum: EMC » Question about emc crystal numbering

Home » PANDA » PandaRoot » EMC » Question about emc crystal numbering

Show: Today's Messages :: Polls :: Message Navigator

Re: Question about emc crystal numbering [message #9120 is a reply to message #9118]

Thu, 30 July 2009 15:51

StefanoSpataro
Messages: 2736
Registered: June 2005
Location: Torino

first-grade participant

From: *15-87-r.retail.telecomitalia.it

fDetectorID is created at the simulation point (PndEmc), taking all the crystal numbers from the geoemtry volume.
After, this number is propagated into EmcHit/Digi and so on. The functions GetRox(), GetCrystal(), getCopy(), GetModule(), GetXPad() and GetYPad() use only fDetectorID, and if you do not use explicitely the command SetDetectorID(), you cannot change that number.

Report message to a moderator

[Message index]

		Question about emc crystal numbering By: Jens Sören Lange on Tue, 28 July 2009 15:59
		Re: Question about emc crystal numbering By: StefanoSpataro on Tue, 28 July 2009 16:40
		Re: Question about emc crystal numbering By: Jens Sören Lange on Wed, 29 July 2009 15:47
		Re: Question about emc crystal numbering By: mpeliz on Wed, 29 July 2009 22:27
		Re: Question about emc crystal numbering By: StefanoSpataro on Thu, 30 July 2009 09:03
		Re: Question about emc crystal numbering By: Jens Sören Lange on Thu, 30 July 2009 15:26
		Re: Question about emc crystal numbering By: StefanoSpataro on Thu, 30 July 2009 15:51

Previous Topic:	forward endcap quest goes on
Next Topic:	change of geometry for EMC

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 04 06:38:19 CEST 2026

Total time taken to generate the page: 0.00749 seconds