GSI Forum: EMC » Question about GetEnergyCorrected()

Home » PANDA » PandaRoot » EMC » Question about GetEnergyCorrected()

Show: Today's Messages :: Polls :: Message Navigator

Re: Question about GetEnergyCorrected() [message #8555 is a reply to message #8553]

Thu, 14 May 2009 11:22

Dima Melnychuk
Messages: 213
Registered: April 2004
Location: National Centre for Nucle...

first-grade participant

From: *fuw.edu.pl

Hi Donghee,

This correction takes into account energy losses due to leakage and energy thresholds for single crystal - 3 MeV.

It is roughly 3 %, but is dependent on energy and theta angle.

The correction implemented in GetEnergyCorrected() function is ported from the old framework and should be redone in pandaroot (since different version of Geant4 are used) but it still roughly do the job.

And in principle it should be latter replaced by the calibration for example on pi0 or eta mass, but this part of software is still missing.

Best regards,
Dima

Report message to a moderator

[Message index]

		Question about GetEnergyCorrected() By: donghee on Thu, 14 May 2009 10:24
		Re: Question about GetEnergyCorrected() By: Dima Melnychuk on Thu, 14 May 2009 11:22
		Re: Question about GetEnergyCorrected() By: Bertram Kopf on Thu, 14 May 2009 11:39
		Re: Question about GetEnergyCorrected() By: donghee on Thu, 14 May 2009 11:28

Previous Topic:	Possible optimization of EMC data classes
Next Topic:	Mass calculation from vector<PndEmcDigi*> in EMC

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Oct 05 00:16:07 CEST 2026

Total time taken to generate the page: 0.00777 seconds