GSI Forum: Monte Carlo Engines » EmProcess threshold

Home » PANDA » PandaRoot » Monte Carlo Engines » EmProcess threshold

Show: Today's Messages :: Polls :: Message Navigator

Re: EmProcess threshold [message #7681 is a reply to message #7679]

Wed, 14 January 2009 16:51

Valery Rodionov
Messages: 5
Registered: May 2007
Location: JINR

occasional visitor

From: *jinr.ru

Hi Mohammad

Thank you for an answer

Yes, Geant4 gives an unique treatment of cuts as _range cuts_, which are converted to energy in each material.
By changing the range cut for a particle one can not go below
990 eV energy threshold, and this can
only be done by changing the _energy_ cut in ProductionCutsTable.
It was my question.

The same situation in the frame of pandaroot?

Valera

Report message to a moderator

[Message index]

		EmProcess threshold By: Valery Rodionov on Wed, 14 January 2009 08:31
		Re: EmProcess threshold By: Mohammad Al-Turany on Wed, 14 January 2009 15:38
		Re: EmProcess threshold By: Valery Rodionov on Wed, 14 January 2009 16:51
		Re: EmProcess threshold By: Mohammad Al-Turany on Thu, 15 January 2009 11:06
		Re: EmProcess threshold By: Valery Rodionov on Thu, 15 January 2009 12:29

Previous Topic:	Energy loss in EMC: bug solved
Next Topic:	GEANT3: of energy loss and delta rays

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 04 08:11:04 CEST 2026

Total time taken to generate the page: 0.00720 seconds