GSI Forum: General » Using cmake

Home » PANDA » PandaRoot » General » Using cmake

Show: Today's Messages :: Polls :: Message Navigator

Re: Error when calling config.sh [message #4571 is a reply to message #4569]

Tue, 26 June 2007 14:52

Florian Uhlig
Messages: 424
Registered: May 2007

first-grade participant

From: *gsi.de

Hi Sebastian

There is a file missing/at the wrong place in your GEANT4 installation. In the subdirectory transport/geant4 below $SIMPATH the file env.sh is missing. Copy the file from transport/geant4/source to transport/geant4.
Then everything should work.

Ciao

Florian

Report message to a moderator

[Message index]

		Using cmake By: Ralf Kliemt on Fri, 15 June 2007 15:07
		Re: Using cmake By: Mohammad Al-Turany on Mon, 18 June 2007 08:38
		Re: Using cmake By: Tobias Stockmanns on Thu, 21 June 2007 14:47
		Re: Using cmake By: Florian Uhlig on Fri, 22 June 2007 19:35
		Re: Using cmake By: Tobias Stockmanns on Mon, 25 June 2007 09:44
		Re: Using cmake By: Florian Uhlig on Mon, 25 June 2007 10:35
		Re: Using cmake By: Tobias Stockmanns on Mon, 25 June 2007 11:44
		Re: Using cmake By: Florian Uhlig on Mon, 25 June 2007 12:01
		Error when calling config.sh By: Sebastian Neubert on Tue, 26 June 2007 14:33
		Re: Error when calling config.sh By: Florian Uhlig on Tue, 26 June 2007 14:52
		Re: Error when calling config.sh By: StefanoSpataro on Tue, 26 June 2007 15:10
		Re: Using cmake By: Sebastian Neubert on Tue, 26 June 2007 16:14

Previous Topic:	More than one working copy
Next Topic:	Discussion Coding rules, Quality Assurance and Control

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun May 17 22:24:14 CEST 2026

Total time taken to generate the page: 0.00666 seconds