GSI Forum: FutureDAQ - Time Distribution » How to interface SADC to Time distribution

Home » FutureDAQ » FutureDAQ - Time Distribution » How to interface SADC to Time distribution

Show: Today's Messages :: Polls :: Message Navigator

Re: How to interface SADC to Time distribution [message #329 is a reply to message #307]

Mon, 19 April 2004 15:54

Lars Schmitt
Messages: 47
Registered: April 2004
Location: GSI

continuous participant

The SADC is interfaced to the TCS via the multiplexer board.
This incorporates an optical TCS receiver decoding clock, reset
and (depending on the application) trigger signals. The SADC
as such is not a standalone module. It is always programmed and
read out via the multiplexer card, to which up to 8 SADC are
attached. The MUX can also be cascaded to multiplex 8 other
MUXes. It distributes the clock signals etc. via optical connections
and the Hotlink protocol like a fanout to the
attached SADCs (or MUXes).

Report message to a moderator

[Message index]

		How to interface SADC to Time distribution By: Walter F.J. Müller on Tue, 13 April 2004 19:23
		Re: How to interface SADC to Time distribution By: Lars Schmitt on Mon, 19 April 2004 15:54
		Re: How to interface SADC to Time distribution By: Igor Konorov on Fri, 30 April 2004 16:48

Next Topic:

Time protocols used for SADC

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Sep 07 17:33:09 CEST 2026

Total time taken to generate the page: 0.00716 seconds