GSI Forum: General » How to write Macros with newest trunk code

Home » PANDA » PandaRoot » General » How to write Macros with newest trunk code

Show: Today's Messages :: Polls :: Message Navigator

Re: How to write Macros with newest trunk code [message #21445 is a reply to message #21440]

Fri, 15 September 2017 09:23

Ralf Kliemt
Messages: 508
Registered: May 2007
Location: GSI, Darmstadt

first-grade participant

From: *dyn.telefonica.de

Hallo Stefan,

Just to be clear on your setup: Did you install
FairSoft may16p1
FairRoot v-17.03
PandaRoot trunk
ROOT version 6
?

The macros in macro/run are phasing out. Please go on in macro/master for the default configuration.
I know there is a double free message upon quitting root 6, which should not harm the calculations.
Other than that, some error message log would be helpful.

Cheers!
Ralf

Report message to a moderator

[Message index]

		How to write Macros with newest trunk code By: Stefan Pflueger on Thu, 14 September 2017 18:11
		Re: How to write Macros with newest trunk code By: Ralf Kliemt on Fri, 15 September 2017 09:23
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 09:54
		Re: How to write Macros with newest trunk code By: Tobias Stockmanns on Fri, 15 September 2017 10:11
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 10:38
		Re: How to write Macros with newest trunk code By: Florian Uhlig on Fri, 15 September 2017 12:59
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 13:09
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 15:37
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 10:22

Previous Topic:	Dirc geometry - current version?
Next Topic:	DAY1 tracking (2017)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun May 24 06:34:06 CEST 2026

Total time taken to generate the page: 0.00896 seconds