GSI Forum: Analysis » Fitters and hyperons

Home » PANDA » PandaRoot » Analysis » Fitters and hyperons

Show: Today's Messages :: Polls :: Message Navigator

Re: Fitters and hyperons [message #20506 is a reply to message #20502]

Mon, 13 March 2017 10:02

Ralf Kliemt
Messages: 508
Registered: May 2007
Location: GSI, Darmstadt

first-grade participant

From: *gsi.de

Hi Karin,

I'll go by the numbers. However, I attached an overview (from back in 2014) on the fitters which you may find interesting.

1) Our Vertex fit is properly tested with min. two helices. Neutrals were just attached to the vertex, but not included in the fit. The addition of the neutrals in the PndKinVtxFit has to be re-checked.

2) The treefitter is prepared to fit neutrals as lines and charged particles as approximated lines (to be revisited) close to a pre-calculated vertex. Setting mass constraints of narrow states is favorable.

3) The 4C fit does not care about vertices. Every particle should have been propagated on its trajectory to its creation point. The 4C fit does only use the four-momenta of the final state particles. You can make a combined particle being treated as final state particle by using Lock().

Cheers!
Ralf