GSI Forum: General Discussions » CALIFA-SiTracker-GLAD geometry conflict

Home » R3BRoot » General Discussions » CALIFA-SiTracker-GLAD geometry conflict

Show: Today's Messages :: Polls :: Message Navigator

Re: CALIFA-SiTracker-GLAD geometry conflict [message #20498 is a reply to message #20496]

Thu, 09 March 2017 19:25

Hector Alvarez Pol
Messages: 21
Registered: July 2015
Location: Univ. Santiago de Compost...

occasional visitor

From: *usc.es

Hi Ana,

last time I was testing the CALIFA position, it was correctly located with respect to the nominal target position.
If this is true, the magnet is misplaced by around half a meter in this geometry file.

For a fast check to determine if CALIFA is correctly centered, you could find where the origin is in your plot or simply visualize a reaction vertex...
the CALIFA barrel should be located as it is in the attached picture (side view).
A displacement of half a meter as it is shown in your pic would mean that the vertex could be located outside the Barrel.

Regards,

Attachment: 1211.jpg
(Size: 742.80KB, Downloaded 1376 times)

Report message to a moderator

[Message index]

		CALIFA-SiTracker-GLAD geometry conflict By: Anna Corsi on Wed, 08 March 2017 16:26
		Re: CALIFA-SiTracker-GLAD geometry conflict By: Hector Alvarez Pol on Thu, 09 March 2017 19:25
		Re: CALIFA-SiTracker-GLAD geometry conflict By: Michael Heil on Mon, 13 March 2017 14:41
		Re: CALIFA-SiTracker-GLAD geometry conflict By: Anna Corsi on Tue, 14 March 2017 22:31

Previous Topic:	Experimental verification of the Geant4 physics list for S438
Next Topic:	Changes to Detector Constructors for Simulations

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Aug 18 14:56:54 CEST 2026

Total time taken to generate the page: 0.00955 seconds