GSI Forum: Simulation Issues » Particle reached max step number

Home » R3BRoot » Simulation Issues » Particle reached max step number

Show: Today's Messages :: Polls :: Message Navigator

Re: Particle reached max step number [message #19447 is a reply to message #19446]

Thu, 18 August 2016 11:17

Dmytro Kresan
Messages: 166
Registered: June 2004

first-grade participant

From: *gsi.de

Yes, you are right. Another try.

15000 limit is set in the file macros/r3b/actar/r3ball.C :

Int_t nSteps = -15000;
gMC->SetMaxNStep(nSteps);

In addition, concerning step size. In the same directory the file g4config2.in (currently) :

/run/setCut 1. mm
/run/setCutForRegion ArCO2 1. um

Best regards,
Dima

Report message to a moderator

[Message index]

		Particle reached max step number By: Oleg on Thu, 18 August 2016 10:37
		Re: Particle reached max step number By: Dmytro Kresan on Thu, 18 August 2016 10:53
		Re: Particle reached max step number By: Oleg on Thu, 18 August 2016 11:07
		Re: Particle reached max step number By: Dmytro Kresan on Thu, 18 August 2016 11:17
		Re: Particle reached max step number By: Oleg on Thu, 18 August 2016 11:25
		Re: Particle reached max step number By: Dmytro Kresan on Thu, 18 August 2016 11:36

Previous Topic:	SimpleAtomPhotoAbsCS
Next Topic:	Geant3 crash on ions

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Aug 21 21:17:18 CEST 2026

Total time taken to generate the page: 0.00674 seconds