GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » R3BRoot » Installation and Compilation » Installation instructions for R3BRoot with UCESB
Re: Installation instructions for R3BRoot with UCESB [message #18892 is a reply to message #18891] Mon, 18 January 2016 10:07 Go to previous message
Ralf Plag is currently offline  Ralf Plag
Messages: 25
Registered: September 2015
continuous participant
 From: *hsi8.kabel-badenwuerttemberg.de
Hi Dima,

I was referring to the error that a non-standard compiler is used.
The cmake stops but actually already suggests a fix: adding some option to the cmake command.
If this option is applied once, it remembers it the next time and then runs fine (without explicitely setting the option).

Cheers,
Ralf

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: dev branch does not compile
Next Topic: ucesb compilation problem
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu May 14 07:28:29 CEST 2026

Total time taken to generate the page: 0.00891 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software