GSI Forum: Particle Identification » How to implement Various PID Criteria for the analysis??

Home » PANDA » PandaRoot » Particle Identification » How to implement Various PID Criteria for the analysis??

Show: Today's Messages :: Polls :: Message Navigator

Re: How to implement Various PID Criteria for the analysis?? [message #18846 is a reply to message #18825]

Tue, 05 January 2016 10:23

Ralf Kliemt
Messages: 508
Registered: May 2007
Location: GSI, Darmstadt

first-grade participant

From: *gsi.de

Hello Ajay.

I can see a few reasons why you don't see differences, those may overlap.

- Selection of keywords: "All" up to "Loose" is for particles with a low likelihood for your hypothesis. Here are the cut values connected to the keywords (defaults in macro/params/all.par):
0.00 - "All"
0.00 - "VeryLoose"
0.25 - "Loose"
0.50 - "Tight"
0.90 - "VeryTight"

- Your channel: Your signals that survive the simulations/reconstruction and you selection may be just identified very well. Signal Protons should stick out quite well against signal pions.

- Simulation setup. Depending if it is full or fast simulations, how well the forward part is implemented, etc. you'll find various PID efficiencies.

Cheers!
Ralf

Report message to a moderator

[Message index]

		How to implement Various PID Criteria for the analysis?? By: Ajay Kumar on Thu, 10 December 2015 12:11
		Re: How to implement Various PID Criteria for the analysis?? By: StefanoSpataro on Thu, 10 December 2015 22:33
		Re: How to implement Various PID Criteria for the analysis?? By: Ralf Kliemt on Tue, 05 January 2016 10:23

Previous Topic:	Faster PndPidCorrelator with smart MVD Info
Next Topic:	Forward TOF particle identification

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Oct 05 10:02:05 CEST 2026

Total time taken to generate the page: 0.00858 seconds