GSI Forum: NUSTAR PRESPEC » FINGER ToF detector

Home » NUSTAR » NUSTAR PRESPEC » FINGER ToF detector

Show: Today's Messages :: Polls :: Message Navigator

Re: FINGER ToF detector [message #17162 is a reply to message #17133]

Tue, 12 August 2014 12:56

thuyuk
Messages: 68
Registered: July 2014

continuous participant

From: *ific.uv.es

Hi Liliana,

Thank you very much for response. I have calibrated the raw QDC spectra of the Finger detectors. But, somehow, I couldn't make it work.

I wanted to give a try to the new approach to find the times in the Finger detector, i.e. the one based on the timing of the signals. I downloaded the new processors written for this purpose and compiled them. So they are ready to use.

But I have some issues with some of the parameters:

1- time_gate is put to select the peak of the time difference between one side of Sci41 and each strips of the finger detector, if I'm not wrong. Is that correct what I figured out?

2- After getting the differences mentioned above, a hit_cal calibration is applied. I have concerns to find these calibration coefficients. In which way it has to be done? Do you use the calibration runs?

Thank you!
Tayfun

Report message to a moderator

[Message index]

		FINGER ToF detector By: thuyuk on Tue, 05 August 2014 12:13
		Re: FINGER ToF detector By: mlcortes on Thu, 07 August 2014 17:57
		Re: FINGER ToF detector By: thuyuk on Fri, 08 August 2014 16:13
		Re: FINGER ToF detector By: mlcortes on Mon, 11 August 2014 11:11
		Re: FINGER ToF detector By: thuyuk on Tue, 12 August 2014 12:56
		Re: FINGER ToF detector By: mlcortes on Wed, 13 August 2014 10:12
		Re: FINGER ToF detector By: thuyuk on Wed, 13 August 2014 12:34

Previous Topic:	Welcome
Next Topic:	problem with a processor (software-wise)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Jun 30 16:42:12 CEST 2026

Total time taken to generate the page: 0.00790 seconds