GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » NUSTAR » NUSTAR PRESPEC » problem with a processor (software-wise)
Re: problem with a processor (software-wise) [message #17155 is a reply to message #17153] Mon, 11 August 2014 14:07 Go to previous messageGo to previous message
miree is currently offline  miree
Messages: 71
Registered: June 2014
continuous participant
 From: *ikp.physik.tu-darmstadt.de
Hi Tayfun,

A comment to your statement: "I want a put a condition on an array". This can mean many different things:

A few examples: It can mean that the condition is fulfilled if
1) all of the array entries fulfill a condition.
2) at least one of the array entries to fulfill a condition
3) at least half of the entries are inside a gate.
4) the size of the array is larger than 5
....

Some of these cases can be achieved by combinations of existing processors.
In order to achieve 2), you could do the following:
Use an UTILS.ArrayFilter that picks out all array entries that fulfill a condition.
Determine the size of the filtered array with the processor UTILS.ArraySize.
Make a condition with UTILS.ConditionWindow1D and make the gate go from 1 to 1000 (a large value).

Michael

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: FINGER ToF detector
Next Topic: LYCCA - w-DSSSD Time Gated
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri May 22 04:44:21 CEST 2026

Total time taken to generate the page: 0.00786 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software