GSI Forum: Analysis » Differences between Histo and Ntuple

Home » PANDA » PandaRoot » Analysis » Differences between Histo and Ntuple

Show: Today's Messages :: Polls :: Message Navigator

Re: Differences between Histo and Ntuple [message #16542 is a reply to message #16539]

Wed, 07 May 2014 19:29

Klaus Götzen
Messages: 293
Registered: June 2006
Location: GSI

first-grade participant

From: *adsl.alicedsl.de

Hi Mamen,

are the entries at -1000 or at -999? Because you see, that the default value of the column is -999.0:

ntp->Column("eppx",  (Float_t) eplus[j]->Px(), -999.0f);

In case you call ntp->DumpData() without filling in a value after the last DumpData, the default value will be stored. So you might check whether sometimes (perhaps somewhere else) ntp->DumpData() is called (accidently).

Best,
Klaus

Report message to a moderator

[Message index]

		Differences between Histo and Ntuple By: Mamen on Wed, 07 May 2014 16:11
		Re: Differences between Histo and Ntuple By: StefanoSpataro on Wed, 07 May 2014 17:37
		Re: Differences between Histo and Ntuple By: Klaus Götzen on Wed, 07 May 2014 19:29
		Re: Differences between Histo and Ntuple By: Mamen on Thu, 08 May 2014 17:25

Previous Topic:	Ideal PID in full simulation
Next Topic:	hyperon fast simualtions

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Aug 21 21:19:37 CEST 2026

Total time taken to generate the page: 0.00753 seconds