GSI Forum: General » pbarpSystem

Home » PANDA » PandaRoot » General » pbarpSystem

Show: Today's Messages :: Polls :: Message Navigator

Re: pbarpSystem [message #15117 is a reply to message #15094]

Wed, 07 August 2013 11:24

Simon Reiter
Messages: 44
Registered: May 2013

continuous participant

From: *zeu.uni-giessen.de

Thank you very much for this introduction.
But why do i have to use these?
ChangeMassMin dummy00_1 [min-mass-value]
ChangeMassMax dummy00_1 [min-mass-value]
I'd set the max deviation from mass in evt.pdl to 0. Is this possible, too?

Report message to a moderator

[Message index]

		pbarpSystem By: Simon Reiter on Mon, 05 August 2013 12:47
		Re: pbarpSystem By: Klaus Götzen on Mon, 05 August 2013 14:14
		Re: pbarpSystem By: StefanoSpataro on Mon, 05 August 2013 15:15
		Re: pbarpSystem By: Jens Sören Lange on Mon, 05 August 2013 16:48
		Re: pbarpSystem By: StefanoSpataro on Mon, 05 August 2013 19:09
		Re: pbarpSystem By: Simon Reiter on Mon, 05 August 2013 15:33
		Re: pbarpSystem By: Simon Reiter on Tue, 06 August 2013 11:19
		Re: pbarpSystem By: Elisabetta Prencipe (2) on Wed, 07 August 2013 00:21
		Re: pbarpSystem By: Simon Reiter on Wed, 07 August 2013 11:24
		Re: pbarpSystem By: Elisabetta Prencipe (2) on Wed, 07 August 2013 11:51
		Re: pbarpSystem By: Simon Reiter on Wed, 07 August 2013 14:04
		Re: pbarpSystem By: Elisabetta Prencipe (2) on Wed, 07 August 2013 14:36
		Re: pbarpSystem By: Simon Reiter on Wed, 07 August 2013 14:50
		Re: pbarpSystem By: Elisabetta Prencipe (2) on Wed, 07 August 2013 16:48

Previous Topic:	How to apply transformations on the geometry? (Alignment)
Next Topic:	Why is there a hardcoded $PATH in config.sh?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 04 04:51:47 CEST 2026

Total time taken to generate the page: 0.01224 seconds