GSI Forum: Monte Carlo Engines » G4 simulation: No MCPoint where one should be...

Home » PANDA » PandaRoot » Monte Carlo Engines » G4 simulation: No MCPoint where one should be...

Show: Today's Messages :: Polls :: Message Navigator

Re: G4 simulation: No MCPoint where one should be... [message #14631 is a reply to message #14604]

Thu, 18 April 2013 11:12

Simone Esch
Messages: 37
Registered: August 2010
Location: Forschungszentrum Jülich...

continuous participant

From: *ikp.kfa-juelich.de

Hello stefano,

Tobias thought about this also, and inserted an output to check this.
Unfortionally something with the seed-setting is wrong, so we could not simulate the exactly the same events. But we saw the not existing MCPoint on other events where we are sure that energy was deposit.

But I can post another event with a higher verbose level.

Concerning the geant4 warning, the track goes further downstream and stops then at some point far away from the MVD, this are really two different things.

Greetings

Simone

Report message to a moderator

[Message index]

		G4 simulation: No MCPoint where one should be... By: Simone Esch on Thu, 11 April 2013 11:07
		Re: G4 simulation: No MCPoint where one should be... By: StefanoSpataro on Thu, 11 April 2013 16:07
		Re: G4 simulation: No MCPoint where one should be... By: Simone Esch on Thu, 18 April 2013 11:12

Previous Topic:	Different geometry treatment in Geant3 and Geant4
Next Topic:	Reco error at Geant4 simulation

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 14 08:44:57 CEST 2026

Total time taken to generate the page: 0.01226 seconds