GSI Forum: Tracking » eta_c generation with EvtGen

Home » PANDA » PandaRoot » Tracking » eta_c generation with EvtGen

Show: Today's Messages :: Polls :: Message Navigator

Re: eta_c generation with EvtGen [message #12840 is a reply to message #12839]

Thu, 01 December 2011 15:48

StefanoSpataro
Messages: 2736
Registered: June 2005
Location: Torino

first-grade participant

From: *to.infn.it

Hi,
I just sent eta_c runs 926fix and 926cufix with pbarpSystem as initial state.
Before sending also the psi jobs I would like to check results with the new "fix" code for eta_c, and also the results for the "normal" psi.

Today the grid should be a bit faster than yesterday, we have back KVI fully operational and also Vienna.

Report message to a moderator

[Message index]

		eta_c generation with EvtGen By: Dima Melnychuk on Thu, 01 December 2011 12:44
		Re: eta_c generation with EvtGen By: StefanoSpataro on Thu, 01 December 2011 15:48
		Re: eta_c generation with EvtGen By: Dima Melnychuk on Fri, 02 December 2011 14:35
		Re: eta_c generation with EvtGen By: StefanoSpataro on Fri, 02 December 2011 20:52
		Re: eta_c generation with EvtGen By: Dima Melnychuk on Sat, 03 December 2011 23:35
		Re: eta_c generation with EvtGen By: StefanoSpataro on Sun, 04 December 2011 01:24
		Re: eta_c generation with EvtGen By: StefanoSpataro on Tue, 06 December 2011 23:24

Previous Topic:	Multipion Results Run906-916
Next Topic:	eta_c results with event mixing

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun May 24 16:42:56 CEST 2026

Total time taken to generate the page: 0.00774 seconds