GSI Forum: Alice TRD chamber construction » Drift HV to Radiator connection

Home » Alice » Alice TRD chamber construction » Drift HV to Radiator connection

Show: Today's Messages :: Polls :: Message Navigator

Re: Drift HV to Radiator connection [message #1231 is a reply to message #966]

Mon, 06 December 2004 14:49

fateev
Messages: 2
Registered: November 2004

occasional visitor

From: 159.93.123*

Hello, Clemens
The other thing I'm not so sure about is the long term gas tighness of silver epoxy. So far we 'repair' scratches in the Radiator surface with silver epoxy, to make sure that the radiator surface is gas tight. If the silver epoxy is not keeping tight on the long term, this might create serious deterioration of chamber performance.
Does anyone have experience with this?
I have a question about gas tight. We remove only Al mylar foil and sand a little black carbon plastic. may be this carbon plastic provides anough good gas tight?

Oleg

Report message to a moderator

[Message index]

		Drift HV to Radiator connection By: Clemens Adler on Thu, 23 September 2004 09:23
		Re: Drift HV to Radiator connection By: Harald Appelshaeuser on Thu, 23 September 2004 11:36
		Re: Drift HV to Radiator connection By: fateev on Mon, 06 December 2004 14:49
		Re: Drift HV to Radiator connection By: Clemens Adler on Mon, 06 December 2004 14:58
		Re: Drift HV to Radiator connection By: Chilo Garabatos on Tue, 25 January 2005 16:42
		Re: Drift HV to Radiator connection By: Clemens Adler on Tue, 25 January 2005 17:06
		Re: Drift HV to Radiator connection By: Chilo Garabatos on Tue, 25 January 2005 17:57
		Re: Drift HV to Radiator connection By: Clemens Adler on Tue, 25 January 2005 18:19
		Re: Drift HV to Radiator connection By: Chilo Garabatos on Mon, 14 February 2005 18:52
		Re: Drift HV to Radiator connection By: Clemens Adler on Tue, 15 February 2005 09:15

Previous Topic:	Anode Wire Problem Summary and Conclusion
Next Topic:	Chamber Construction Manual: new version

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 04 11:41:56 CEST 2026

Total time taken to generate the page: 0.00818 seconds