GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » PANDA » PandaRoot » Bugs, Fixes, Releases » Question about geometryversion for EMC
Re: Question about geometryversion for EMC [message #11877 is a reply to message #11876] Wed, 25 May 2011 10:38 Go to previous messageGo to previous message
StefanoSpataro is currently offline  StefanoSpataro
Messages: 2736
Registered: June 2005
Location: Torino
first-grade participant
From: *to.infn.it
Some time ago I have seen that running complete simulation with DPM (10k events), after a while the simulation exits without giving error messages at all. This should be a matter of memory, when it is completely filled (if I remember well).
I have seen that removing the fsc from simulation (emc geometry type 19), this does not happen anymore... My fear that this is connected to the higher number of secondaries, due to the separated physics lists (SetSpecialCuts gMC->SetMaxNStep((int)1E6)Wink, or something similar.

Maybe it could be good if a check on the stability for large number of events is performed for such geometry, for sure we want to reduce the risks of crashing macrocand I have taken it out for the TDR production.
Could you please check this point?
Thanks in advance.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Reconstruction macro crush - PndMCTrackAssociator
Next Topic: Dart.sh ncpu issue
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Jul 23 23:40:28 CEST 2026

Total time taken to generate the page: 0.00835 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software