GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » PANDA » PandaRoot » EMC » EmcHitProducer in simulation
EmcHitProducer in simulation [message #9783] Wed, 25 November 2009 16:30
StefanoSpataro is currently offline  StefanoSpataro
Messages: 2736
Registered: June 2005
Location: Torino
first-grade participant
From: *to.infn.it
Dear EMC developers/users,
I have updated the macros sim_emc.C and full_emc.C, so that from now the EmcHitProducer is inside the simulation part and not in the digitization anymore.

I have checked the gain in disk space.

I have run 1000 photons at 1GeV, with full barrel setup.
The followings are the values of file size:

EMC point+hit  36M
EMC only hit    5M


The gain is quite important, I would say.
Slowly all the macros should use this scheme.

Report message to a moderator

[Message index]
 
Read Message
Previous Topic: EMC Geometry handling.
Next Topic: Removal of obsolete macros in emc
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Dec 19 20:30:32 CET 2025

Total time taken to generate the page: 0.00747 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software