GSI Forum: General » Moving the Geometry from data file to the parameters

Home » CBM » CBMROOT » General » Moving the Geometry from data file to the parameters

Mon, 26 October 2009 11:32

Arun Prakash
Messages: 11
Registered: March 2008
Location: Department of Physics,BHU...

occasional visitor

From: *gsi.de

I am using the trunk version of cbmroot

Best Regards

Arun Prakash

		Moving the Geometry from data file to the parameters By: Mohammad Al-Turany on Wed, 23 September 2009 12:33
		Re: Moving the Geometry from data file to the parameters By: Elena Litvinenko on Fri, 23 October 2009 16:21
		Re: Moving the Geometry from data file to the parameters By: Mohammad Al-Turany on Mon, 26 October 2009 09:09
		Re: Moving the Geometry from data file to the parameters By: Elena Litvinenko on Mon, 26 October 2009 09:27
		Re: Moving the Geometry from data file to the parameters By: Arun Prakash on Mon, 26 October 2009 11:30
		Re: Moving the Geometry from data file to the parameters By: Arun Prakash on Mon, 26 October 2009 11:32
		Re: Moving the Geometry from data file to the parameters By: Mohammad Al-Turany on Mon, 26 October 2009 21:48

Previous Topic:	Control of Cuts for Geant4 in CBMRoot
Next Topic:	CBMROOT release DEC09

Goto Forum:

] [

]

Current Time: Sun Nov 24 02:52:33 CET 2024

Total time taken to generate the page: 0.00817 seconds