GSI Forum: General » Moving the Geometry from data file to the parameters

Home » CBM » CBMROOT » General » Moving the Geometry from data file to the parameters

Mon, 26 October 2009 09:27

Elena Litvinenko
Messages: 20
Registered: March 2004
Location: JINR, Dubna

occasional visitor

From: *jinr.ru

Hi. Mohammad,

Thanks for the hint with

file->Get("FairBaseParSet");

(I knew about libTrd Razz

)

Regards,
Elena

[Updated on: Mon, 26 October 2009 09:28]

		Moving the Geometry from data file to the parameters By: Mohammad Al-Turany on Wed, 23 September 2009 12:33
		Re: Moving the Geometry from data file to the parameters By: Elena Litvinenko on Fri, 23 October 2009 16:21
		Re: Moving the Geometry from data file to the parameters By: Mohammad Al-Turany on Mon, 26 October 2009 09:09
		Re: Moving the Geometry from data file to the parameters By: Elena Litvinenko on Mon, 26 October 2009 09:27
		Re: Moving the Geometry from data file to the parameters By: Arun Prakash on Mon, 26 October 2009 11:30
		Re: Moving the Geometry from data file to the parameters By: Arun Prakash on Mon, 26 October 2009 11:32
		Re: Moving the Geometry from data file to the parameters By: Mohammad Al-Turany on Mon, 26 October 2009 21:48

Previous Topic:	Control of Cuts for Geant4 in CBMRoot
Next Topic:	CBMROOT release DEC09

Goto Forum:

] [

]

Current Time: Tue May 19 02:56:03 CEST 2026

Total time taken to generate the page: 0.00795 seconds