GSI Forum: EMC » Geant3 tracking cuts for the EMC

Home » PANDA » PandaRoot » EMC » Geant3 tracking cuts for the EMC

Show: Today's Messages :: Polls :: Message Navigator

Re: Geant3 tracking cuts for the EMC [message #9579 is a reply to message #9570]

Mon, 19 October 2009 12:10

Christian Hammann
Messages: 24
Registered: July 2009
Location: Bonn

continuous participant

From: *cb.uni-bonn.de

Thank you very much for the cut values, they will be a much better starting point.

Can someone tell me how to set the cuts on a per material basis?

I will also try if I can use geant4, if this was used for the physiksbook that might be an even better starting point.

Cheers
Christian

Christian Hammann
Universität Bonn
Helmholz-Institut für Strahlen und Kernphysik
Nußallee 14-16
53115 Bonn
Tel: +49 228 733895
Fax: +49 228 732505

Report message to a moderator

[Message index]

		Geant3 tracking cuts for the EMC By: Christian Hammann on Fri, 16 October 2009 13:58
		Re: Geant3 tracking cuts for the EMC By: Bertram Kopf on Fri, 16 October 2009 14:40
		Re: Geant3 tracking cuts for the EMC By: Bertram Kopf on Fri, 16 October 2009 15:06
		Re: Geant3 tracking cuts for the EMC By: Bertram Kopf on Fri, 16 October 2009 16:29
		Re: Geant3 tracking cuts for the EMC By: Christian Hammann on Mon, 19 October 2009 12:10
		Re: Geant3 tracking cuts for the EMC By: StefanoSpataro on Fri, 16 October 2009 15:10
		Re: Geant3 tracking cuts for the EMC By: Bertram Kopf on Fri, 16 October 2009 15:25
		Re: Geant3 tracking cuts for the EMC By: StefanoSpataro on Fri, 16 October 2009 15:30
		Re: Geant3 tracking cuts for the EMC By: Jens Sören Lange on Fri, 16 October 2009 17:36
		Re: Geant3 tracking cuts for the EMC By: Christian Hammann on Mon, 19 October 2009 12:00
		Re: Geant3 tracking cuts for the EMC By: Mohammad Al-Turany on Mon, 19 October 2009 15:29

Previous Topic:	Geometry of EMC Barrel Crystal
Next Topic:	Geometry converter for EMC crystals

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 09 18:19:14 CEST 2026

Total time taken to generate the page: 0.01206 seconds