GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » PANDA » PandaRoot » EMC » forward endcap quest goes on
Re: forward endcap quest goes on [message #8959 is a reply to message #8956] Wed, 08 July 2009 14:58 Go to previous messageGo to previous message
mpeliz is currently offline  mpeliz
Messages: 51
Registered: February 2008
Location: Ruhr-Universitaet Bochum
continuous participant
From: *ep1.ruhr-uni-bochum.de
Hello Irina,

as Bertram mentioned in his previous posting the shower in a crystal starts not at the surface, but inside the crystal.
This shift is taken into account in the digitization. We add 6.3 cm
to the position of the crystal in direction of the crystal axis. Therefore the EmcDigi is shifted with respect to the EmcHit.
Taking into account the cos(theta) the observed shift in Ola's plots for digis and hits is consistent with that.
At the moment I do not understand the shift between the digi and the cluster position. I will carefully check.

However, for the reconstruction we usually don't care about the z-position. We should check the reconstructed theta and phi angle in addition. Therefore one should look to the difference of the cluster position (theta, phi) wrt to the corresponding MC truth angles. This is replacing the points in the bottom left picture in points_g4_fwendcap_m3changed_fixed.png by the cluster. Ola could you change your macro and do these plots, please? BTW, is the macro in SVN? If not, could you check it in? This would be helpful for understanding the plots in detail.

Cheers,
Marc


 
Read Message icon5.gif
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Mass calculation from vector<PndEmcDigi*> in EMC
Next Topic: Question about emc crystal numbering
Goto Forum:
  


Current Time: Sun Nov 24 02:57:39 CET 2024

Total time taken to generate the page: 0.00760 seconds