GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » PANDA » PandaRoot » Bugs, Fixes, Releases » CadConvert installation on Debian Etch
Re: CadConvert installation on Debian Etch [message #7712 is a reply to message #7711] Wed, 21 January 2009 17:36 Go to previous message
Tobias Stockmanns is currently offline  Tobias Stockmanns
Messages: 489
Registered: May 2007
first-grade participant
 From: *ikp.kfa-juelich.de
You have to set the variable CASROOT to your [OpenCascade]/ros folder and run the script env.csh (or .ksh) in this folder to configure the OpenCascade environment.

I hope this helps.

Cheers,

Tobias

Report message to a moderator

[Message index]
 
Read Message
Read Message
Previous Topic: problem with external packages installation
Next Topic: Old dashBoard will be switched of
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu May 14 03:25:05 CEST 2026

Total time taken to generate the page: 0.00811 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software