GSI Forum: Bugs, Fixes, Releases » gconfig G3Config.C SetCuts.C

Home » PANDA » PandaRoot » Bugs, Fixes, Releases » gconfig G3Config.C SetCuts.C

Show: Today's Messages :: Polls :: Message Navigator

Re: gconfig G3Config.C SetCuts.C [message #7420 is a reply to message #7419]

Wed, 15 October 2008 16:00

Susanna Costanza
Messages: 33
Registered: January 2008
Location: Pavia

continuous participant

From: *pv.infn.it

Hi Alicia,
months ago I was working on cuts (SetCuts.C and Geane.C) ... so I think it was me that changed TOFMAX value.

I put TOFMAX = 1E10 seconds because it's the value suggested by the Geant User Guide. I quote:

TOFMAX time of flight cut in seconds -> 10^10
and
TOFMAX threshold on time of flight counted from primary interaction time (10^10)

Pay attention that both Geant3 and Geant4 use the same cuts set in SetCuts.C. So the setting of TOFMAX to 1E10 s cannot be the reason of the big difference you see when you simulate using either Geant3 or Geant4.

I hope this can help you.
Ciao,
Susanna

Report message to a moderator

[Message index]

		gconfig G3Config.C SetCuts.C By: asanchez on Wed, 15 October 2008 14:46
		Re: gconfig G3Config.C SetCuts.C By: Susanna Costanza on Wed, 15 October 2008 16:00
		Re: gconfig G3Config.C SetCuts.C By: StefanoSpataro on Wed, 15 October 2008 16:33

Previous Topic:	Problems compiling EvtGen
Next Topic:	simpleEvtGen for fast simulation limited (?)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Mar 19 16:54:48 CET 2026

Total time taken to generate the page: 0.00834 seconds