GSI Forum: General » GEANE: Propagate to Plane not implemented

Home » PANDA » PandaRoot » General » GEANE: Propagate to Plane not implemented

Show: Today's Messages :: Polls :: Message Navigator

Re: GEANE: Propagate to Plane not implemented [message #7417 is a reply to message #7416]

Wed, 15 October 2008 12:26

Lia Lavezzi
Messages: 291
Registered: May 2007
Location: Torino

first-grade participant

From: *pv.infn.it

Hi again,
one more remark: Susanna suggested also that to plot the pull distributions and correctly compare the MC to the GEANE output you need to change some cuts following the instructions in gconfig/SetCuts.C and rerun both the simulation and GEANE.

We are afraid this will not completely solve the problem, but maybe it will improve a little the results.

Lia.

Report message to a moderator

[Message index]

		GEANE: Propagate to Plane not implemented By: Tobias Stockmanns on Wed, 15 October 2008 08:08
		Re: GEANE: Propagate to Plane not implemented By: Mohammad Al-Turany on Wed, 15 October 2008 09:11
		Re: GEANE: Propagate to Plane not implemented By: Tobias Stockmanns on Wed, 15 October 2008 09:48
		Re: GEANE: Propagate to Plane not implemented By: Lia Lavezzi on Wed, 15 October 2008 10:42
		Re: GEANE: Propagate to Plane not implemented By: Tobias Stockmanns on Wed, 15 October 2008 11:29
		Re: GEANE: Propagate to Plane not implemented By: Lia Lavezzi on Wed, 15 October 2008 12:05
		Re: GEANE: Propagate to Plane not implemented By: Lia Lavezzi on Wed, 15 October 2008 12:26
		Re: GEANE: Propagate to Plane not implemented By: Tobias Stockmanns on Wed, 15 October 2008 13:01
		Re: GEANE: Propagate to Plane not implemented By: Lia Lavezzi on Wed, 15 October 2008 19:00
		Re: GEANE: Propagate to Plane not implemented By: Tobias Stockmanns on Thu, 16 October 2008 09:13

Previous Topic:	Materials and radiation lengths in pandaroot
Next Topic:	PndFlatParticleGenerator

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Jun 02 11:55:02 CEST 2026

Total time taken to generate the page: 0.00774 seconds