GSI Forum: General » geane propagate((CbmTrackParH *TStart, CbmTrackParP *TEnd, Int

Home » PANDA » PandaRoot » General » geane propagate((CbmTrackParH *TStart, CbmTrackParP *TEnd, Int_t PDG)

Show: Today's Messages :: Polls :: Message Navigator

Re: geane propagate((CbmTrackParH *TStart, CbmTrackParP *TEnd, Int_t PDG) [message #6655 is a reply to message #6654]

Fri, 02 May 2008 12:37

asanchez
Messages: 350
Registered: March 2006

first-grade participant

From: *kph.uni-mainz.de

Hi again,
i have checked the ertrack.F which is called in
propagate(CbmtrackP, cbmtrackP, pdg) at CbmGeanePro.cxx
and so far i have understood(please let me know if i'm wrong)
the pdg code will be use to obtain
information from the particle which will be used
to do the propagation to a point, plane volume ,etc

let's assume that after the tracking, i have only tracks
and i don't have pdg information any more.
if i don't have the pdg of the particle, means that
geane will not work??.

Is that the case?
Is there any way to use ertrack only providing track parameters
from the fit and the start and end position.?

Thanks
ALicia.

Report message to a moderator

[Message index]

		geane propagate((CbmTrackParH TStart, CbmTrackParP TEnd, Int_t PDG) By: asanchez on Fri, 02 May 2008 12:00
		Re: geane propagate((CbmTrackParH TStart, CbmTrackParP TEnd, Int_t PDG) By: StefanoSpataro on Fri, 02 May 2008 12:04
		Re: geane propagate((CbmTrackParH TStart, CbmTrackParP TEnd, Int_t PDG) By: asanchez on Fri, 02 May 2008 12:37
		Re: geane propagate((CbmTrackParH TStart, CbmTrackParP TEnd, Int_t PDG) By: Lia Lavezzi on Fri, 02 May 2008 15:10

Previous Topic:	charmtask
Next Topic:	New Solenoid and MVD

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun May 11 03:13:39 CEST 2025

Total time taken to generate the page: 0.00894 seconds