GSI Forum: Bugs, Fixes, Releases » decay off in geant4

Home » PANDA » PandaRoot » Bugs, Fixes, Releases » decay off in geant4

Show: Today's Messages :: Polls :: Message Navigator

Re: decay off in geant4 [message #4338 is a reply to message #4333]

Fri, 25 May 2007 10:17

Pablo Genova
Messages: 32
Registered: May 2007

continuous participant

From: *PV.INFN.IT

Hi Alicia,

I think that g4config.C recalls the geant3 physics process control, so it should have the same meaning (cfr geant3 manual).

In GEANT3 if you setdecay(1), i. e. variable IDCAY is one, decay processes are enabled, while with 0 they are disabled, and this is the usual way to enable/disable physics processes.

I tested the setters with other processes in GEANT3 and they working, but I do not know for sure if in geant4 they are working!

ciao, Pablo

Report message to a moderator

[Message index]

		decay off in geant4 By: asanchez on Wed, 16 May 2007 11:10
		Re: decay off in geant4 By: StefanoSpataro on Wed, 16 May 2007 11:16
		Re: decay off in geant4 By: asanchez on Fri, 25 May 2007 09:49
		Re: decay off in geant4 By: StefanoSpataro on Fri, 25 May 2007 09:53
		Re: decay off in geant4 By: asanchez on Fri, 25 May 2007 10:01
		Re: decay off in geant4 By: Pablo Genova on Fri, 25 May 2007 10:17
		Re: decay off in geant4 By: asanchez on Fri, 25 May 2007 10:22
		Re: decay off in geant4 By: Pablo Genova on Fri, 25 May 2007 10:31
		Re: decay off in geant4 By: StefanoSpataro on Fri, 25 May 2007 10:36
		Re: decay off in geant4 By: Pablo Genova on Fri, 25 May 2007 10:47

Previous Topic:	box generator
Next Topic:	Changes in DPM Generator?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 14 14:33:06 CEST 2026

Total time taken to generate the page: 0.00708 seconds