GSI Forum: General Discussion » How to configure cmake when using the current FairRoot/dev?

Home » Fairroot » General Discussion » How to configure cmake when using the current FairRoot/dev?

Show: Today's Messages :: Polls :: Message Navigator

Re: How to configure cmake when using the current FairRoot/dev? [message #23901 is a reply to message #23892]

Tue, 30 April 2019 16:15

Mohammad Al-Turany
Messages: 518
Registered: April 2004
Location: GSI, Germany

first-grade participant

From: *gsi.de

Hi Stefan,

This is not FindPackage2, this is a side effect of moving from self written Find_Geant4.cmake to the Geant4Config.cmake which is delivered by Geant4 itself. Please control that the variables names are the same, i.e: the new variables Geant4_INCLUDE_DIRS and in the Old FindGeant4.cmake it was GEANT4_INCLUDE_DIR.

best,

Mohammad

Report message to a moderator

[Message index]

		How to configure cmake when using the current FairRoot/dev? By: Stefan Pflueger on Tue, 30 April 2019 13:34
		Re: How to configure cmake when using the current FairRoot/dev? By: Mohammad Al-Turany on Tue, 30 April 2019 15:36
		Re: How to configure cmake when using the current FairRoot/dev? By: Stefan Pflueger on Tue, 30 April 2019 16:03
		Re: How to configure cmake when using the current FairRoot/dev? By: Mohammad Al-Turany on Tue, 30 April 2019 16:15
		Re: How to configure cmake when using the current FairRoot/dev? By: Stefan Pflueger on Tue, 30 April 2019 16:16
		Re: How to configure cmake when using the current FairRoot/dev? By: Roman Klasen on Mon, 06 May 2019 13:07

Previous Topic:	Problem installing FairSoft
Next Topic:	Force to compile with C++17 standards

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri May 29 21:37:13 CEST 2026

Total time taken to generate the page: 0.00903 seconds