GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » PANDA » PandaRoot » General » Implementing Software Alignment into PandaROOT
Re: Implementing Software Alignment into PandaROOT [message #21711 is a reply to message #21705] Sun, 05 November 2017 12:58 Go to previous messageGo to previous message
Stefan Pflueger is currently offline  Stefan Pflueger
Messages: 99
Registered: February 2012
continuous participant
 From: *dip0.t-ipconnect.de
Hi Mohammad,

thx for the information! I just checked the sim macro in the fairroot github project template, and there is a line

run->CreateGeometryFile("geofile_full.root");


Is that the way we should save such a geometry (TGeoManager object)?

So for the creation of such full geometries, I can just setup the FairRunAna with the detector modules, call Init() and save the geometry for later use with the line above. Basically it's just like simulation, except I skip the actual simulation part. Is that correct?

And just to clarify, this is the way the alignment studies are supposed to be handled right?

Stefan

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Migration to git
Next Topic: PandaRoot on GIT
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Mar 24 09:42:56 CET 2026

Total time taken to generate the page: 0.00851 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software