GSI Forum: General » How to write Macros with newest trunk code

Home » PANDA » PandaRoot » General » How to write Macros with newest trunk code

Show: Today's Messages :: Polls :: Message Navigator

Re: How to write Macros with newest trunk code [message #21448 is a reply to message #21445]

Fri, 15 September 2017 09:54

Stefan Pflueger
Messages: 99
Registered: February 2012

continuous participant

From: *dip0.t-ipconnect.de

Hi Ralf,

yes exactly that's my configuration. I should add that i used gcc 6.4.0. So everyone gets the double free error messages at the end of the macro runtime? I almost assume so... Because it crashes at the end of the runtime, the macros should still deliver valid output like you said. Strangely most of the output files for the lmd reconstruction chain are empty. I will investigate further today and compare our lmd macros with the master ones. Maybe some change in fairroot etc is not implemented correctly in our lmd macro code up to now.
Nevertheless if everyone using root6 and the trunk code of pandaroot gets these double free issues, its quite embarrassing to me... Because it is a double free at the end of the runtime done by the root "garbage collector", it is also a bit hard to debug that. But I checked some of the code yesterday and there are a lot of delete statements in the code, which could be responsible for this kind of thing. I will post the output later, however I don't think it will be of much help.

Stefan

Report message to a moderator

[Message index]

		How to write Macros with newest trunk code By: Stefan Pflueger on Thu, 14 September 2017 18:11
		Re: How to write Macros with newest trunk code By: Ralf Kliemt on Fri, 15 September 2017 09:23
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 09:54
		Re: How to write Macros with newest trunk code By: Tobias Stockmanns on Fri, 15 September 2017 10:11
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 10:38
		Re: How to write Macros with newest trunk code By: Florian Uhlig on Fri, 15 September 2017 12:59
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 13:09
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 15:37
		Re: How to write Macros with newest trunk code By: Stefan Pflueger on Fri, 15 September 2017 10:22

Previous Topic:	Dirc geometry - current version?
Next Topic:	DAY1 tracking (2017)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue May 19 03:19:03 CEST 2026

Total time taken to generate the page: 0.00679 seconds