GSI Forum: Simulation Issues » Particle reached max step number

Home » R3BRoot » Simulation Issues » Particle reached max step number

Show: Today's Messages :: Polls :: Message Navigator

Re: Particle reached max step number [message #19448 is a reply to message #19447]

Thu, 18 August 2016 11:25

Oleg
Messages: 19
Registered: August 2016
Location: GSI

occasional visitor

From: *gsi.de

In macros/r3b/actar/r3ball.C
there are few lines:

// ------ Increase nb of step for CALO
Int_t nSteps = -15000;
gMC->SetMaxNStep(nSteps);

I was sure it is related to the calorimeter and not our detector. Is it?

In macros/r3b/actar/g4config2.in:

/run/setCut 1. mm
/run/setCutForRegion helium 100. um

Regards, Oleg.

Report message to a moderator

[Message index]

		Particle reached max step number By: Oleg on Thu, 18 August 2016 10:37
		Re: Particle reached max step number By: Dmytro Kresan on Thu, 18 August 2016 10:53
		Re: Particle reached max step number By: Oleg on Thu, 18 August 2016 11:07
		Re: Particle reached max step number By: Dmytro Kresan on Thu, 18 August 2016 11:17
		Re: Particle reached max step number By: Oleg on Thu, 18 August 2016 11:25
		Re: Particle reached max step number By: Dmytro Kresan on Thu, 18 August 2016 11:36

Previous Topic:	SimpleAtomPhotoAbsCS
Next Topic:	Geant3 crash on ions

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Aug 19 23:12:17 CEST 2026

Total time taken to generate the page: 0.00822 seconds