GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » R3BRoot » Installation and Compilation » Installation instructions for R3BRoot with UCESB
Re: Installation instructions for R3BRoot with UCESB [message #18893 is a reply to message #18888] Mon, 18 January 2016 11:24 Go to previous messageGo to previous message
Bastian Löher is currently offline  Bastian Löher
Messages: 8
Registered: October 2015
occasional visitor
 From: *gsi.de
Dima,

as of now no git repository for the ucesb base components exists. Therefore one will have to check out from CVS as written in the README. The git repository for the experiments (upexps) is now much more up to date than the CVS repository.

So here goes:

Ucesb base:
cvs -d :ext:land@lxgs08.gsi.de:/u/johansso/CVS co unpacker

Experiments:
git clone lx-pool.gsi.de:/u/johansso/upexps

Of course it would be nice to have this on a more public location, but this is still a work in progress.
Until then one might think of making tarballs.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: dev branch does not compile
Next Topic: ucesb compilation problem
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Mon Jun 01 11:00:57 CEST 2026

Total time taken to generate the page: 0.00899 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software