GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » NUSTAR » NUSTAR PRESPEC » Multihit TDCs in the PreSPEC setup (CAENv1290) (This topic is intended to collect different ways of treating data from multihit TDCs. Post here whenever you want to share your ideas.)
Re: Multihit TDCs in the PreSPEC setup (CAENv1290) [message #18436 is a reply to message #18419] Wed, 26 August 2015 21:09 Go to previous messageGo to previous message
miree is currently offline  miree
Messages: 71
Registered: June 2014
continuous participant
 From: *084.059.pools.vodafone-ip.de
Hi Tayfun,

With the v1290 multihit-TDC the full resolution of 25ps is only achieved for channel differences. If you make a histogram of one single multihit-TDC channel, it will always show the time distribution of the signal that was put into the channel, but folded with a ~25ns wide jitter. Because the jitter is identical on all channels, it disappears when you look at channel differences.

Concerning your trigger signal: You should see a spike - folded with a 25ns wide jitter signal - which gives a 25ns wide peak.

Michael

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: AGATA Crystal positions (Look-Up Table)
Next Topic: prespec git updates
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Jul 04 12:13:41 CEST 2026

Total time taken to generate the page: 0.00825 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software