GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung

Home » R3BRoot » Simulation Issues » [NeuLAND] New Neuland Digitizer
[NeuLAND] New Neuland Digitizer [message #18412] Thu, 13 August 2015 13:48 Go to previous message
Jan Mayer is currently offline  Jan Mayer
Messages: 20
Registered: August 2015
occasional visitor
From: *ikp.uni-koeln.de
Hello everyone,

I have extracted the logic of the digitization process from land/R3BLandDigitizer into a separate "digitizing engine", used by neuland/R3BNeulandDigitizer.
https://subversion.gsi.de/trac/fairroot/browser/r3broot/trunk/neuland/di gitizing/DigitizingEngine.h

The previous code was quite convoluted, but it turned out that it actually did not do "that much" with many LoC. I hope the smaller, more object oriented pieces are easier to understand.
The output should be about the same, however some of the "constants" that were previously set depending on the physical setup or the beam energy might need some reevaluation, e.g.: https://subversion.gsi.de/trac/fairroot/browser/r3broot/trunk/neuland/di gitizing/DigitizingEngine.cxx#L22
In addition, the code remaining under Exec() in R3BNeulandDigitizer (xyz positions) needs some additional love & care.

I would like to invite everyone to have a look at the code, especially the few parts where actual physics is involved (e.g. parts with '@mheil:').

Any questions or comments is appreciated.

Jan
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: CALIFA Event Display
Next Topic: Some of LandFirstHits are empty - Neutrons simulation.
Goto Forum:
  


Current Time: Sat Nov 30 20:22:09 CET 2024

Total time taken to generate the page: 0.00846 seconds