GSI Forum: Analysis » Ideal PID in full simulation

Home » PANDA » PandaRoot » Analysis » Ideal PID in full simulation

Show: Today's Messages :: Polls :: Message Navigator

Re: Ideal PID in full simulation [message #16544 is a reply to message #16496]

Thu, 08 May 2014 16:21

Elisa Fioravanti
Messages: 84
Registered: January 2008

continuous participant

From: *fe.infn.it

Dear all,

I'm using the full simulation with Ideal PID.
I wrote:

theAnalysis->FillList(muplus, "MuonVeryTightPlus","PidAlgoIdealCharged");
theAnalysis->FillList(muminus, "MuonVeryTightMinus","PidAlgoIdealCharged");

but if I change VeryTight with Loose or Tight, the number of
events is always the same.
(I tried also with the standard macro of the psi(2S)->J/psi pi pi in macro/run)

The pandaroot version is 24830.
What is the standard procedure to set the Ideal PID? Where am I wrong?

Thank you in advance
Elisa

Report message to a moderator

[Message index]

		Ideal PID in full simulation By: Lu Cao on Wed, 30 April 2014 15:09
		Re: Ideal PID in full simulation By: Ralf Kliemt on Wed, 30 April 2014 15:28
		Re: Ideal PID in full simulation By: Lu Cao on Wed, 30 April 2014 15:46
		Re: Ideal PID in full simulation By: Klaus Götzen on Wed, 30 April 2014 15:51
		Re: Ideal PID in full simulation By: Elisa Fioravanti on Thu, 08 May 2014 16:21
		Re: Ideal PID in full simulation By: Ralf Kliemt on Thu, 08 May 2014 16:27

Previous Topic:	[FIXED] Problems with analysis: PidAlgoMvd not found in Tree
Next Topic:	Differences between Histo and Ntuple

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Mar 23 21:13:36 CET 2026

Total time taken to generate the page: 0.00708 seconds