GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » PANDA » PandaRoot » Fast Simulations » [FIXED] Problems with PndKinFitter::AddMassConstraint
Re: Problems with PndKinFitter::AddMassConstraint [message #16540 is a reply to message #16537] Wed, 07 May 2014 17:32 Go to previous messageGo to previous message
StefanoSpataro is currently offline  StefanoSpataro
Messages: 2736
Registered: June 2005
Location: Torino
first-grade participant
From: *to.infn.it
This is a mass constraint fit, you force the total mass being a defined value, and then you use the modified parameters to check other distributions (i.e. you fit the j/psi mass and check the improvement in the resolution of psi mass). The mass must be a delta, or must have sigma much narrower than resolution... in this case you have only one moderate improvement. The 4C fitter works nicely and you have a delta there, or better a very narrow distribution. A broader distribution means that the fit did not converge to a global minimum, and I am not surprised seeing that chi2 distribution.

The main question is: why the chi2 distribution is screwed? Once fixing this, I believe the fitter will produce good results. The fact that the 4C fitters works nicely, in both full and fast sim, means that covariances are fine.

Report message to a moderator

[Message index]
 
Read Message icon8.gif
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: PID arrays in Fast Sim
Next Topic: [FIXED] 4Cfit
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Jul 22 06:14:22 CEST 2026

Total time taken to generate the page: 0.00651 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software