GSI Forum: EMC » EMC resolution

Home » PANDA » PandaRoot » EMC » EMC resolution

Show: Today's Messages :: Polls :: Message Navigator

Re: EMC resolution [message #15670 is a reply to message #15619]

Wed, 06 November 2013 11:13

Ronald Kunne
Messages: 32
Registered: October 2009

continuous participant

From: *in2p3.fr

Some remarks on the EMC resolution problem.

1) the present EMC PID is two years old, release 14213.

2) I think what should be available in PandaRoot ideally is two versions for the cluster energy Eraw et Ecorrected, where Eraw is the cluster energy as close to the value as we will measure it in the experiment, and Ecorrected a software corrected value to be used for gamma tracks and Binsong's electron correction

3) At present there are three values Eraw (non-uniformity off), an Eraw(non-uniformity on) et an Ecalibrated (which is probably wrong, if it uses Eraw). Of these: Eraw(non-uniformity on) represents the best the data as will be measured in the experiment

4) I checked the resolutions using the tuples made recently by Gosia. Eraw and Ecalibrated give resolutions that practically identical and both are too low.

Description of the plot added.
Upper raw: data using Eraw
Lower raw: data using Ecalibrated

1st column: pMC versus (Eemc-pMC)/pMC in %
2st column: profile plot of pMC versus (Eemc-pMC)/pMC in %
3st column: resolution obtained by fitting Gaussians to slices of the 2D histos.

Greetings,
Ronald Kunne

Report message to a moderator

[Message index]

		EMC resolution By: binsong on Fri, 11 October 2013 14:05
		Re: EMC resolution By: Dima Melnychuk on Mon, 14 October 2013 14:47
		Re: EMC resolution By: StefanoSpataro on Mon, 14 October 2013 17:29
		Re: EMC resolution By: binsong on Wed, 30 October 2013 10:50
		Re: EMC resolution By: StefanoSpataro on Wed, 30 October 2013 14:57
		Re: EMC resolution By: Dima Melnychuk on Wed, 30 October 2013 15:23
		Re: EMC resolution By: Ronald Kunne on Wed, 06 November 2013 11:13
		Re: EMC resolution By: Dima Melnychuk on Wed, 06 November 2013 12:35
		Re: EMC resolution By: StefanoSpataro on Wed, 06 November 2013 17:11
		Re: EMC resolution By: binsong on Fri, 15 November 2013 15:10
		Re: EMC resolution By: Dima Melnychuk on Fri, 15 November 2013 15:24
		Re: EMC resolution By: binsong on Fri, 15 November 2013 15:30
		Re: EMC resolution By: StefanoSpataro on Fri, 15 November 2013 16:23
		Re: EMC resolution By: binsong on Fri, 15 November 2013 16:30
		Re: EMC resolution By: StefanoSpataro on Fri, 15 November 2013 16:35
		Re: EMC resolution By: Dima Melnychuk on Fri, 15 November 2013 15:39
		Re: EMC resolution By: binsong on Fri, 15 November 2013 15:49
		Re: EMC resolution By: binsong on Thu, 13 February 2014 15:16
		Re: EMC resolution By: binsong on Thu, 13 February 2014 15:17

Previous Topic:	[FIXED] About negative track id -2
Next Topic:	An idea for EMC Error matix

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 04 11:30:04 CEST 2026

Total time taken to generate the page: 0.00653 seconds