GSI Forum: Monte Carlo Engines » Reco error at Geant4 simulation

Home » PANDA » PandaRoot » Monte Carlo Engines » Reco error at Geant4 simulation

Show: Today's Messages :: Polls :: Message Navigator

Re: Reco error at Geant4 simulation [message #15644 is a reply to message #15625]

Fri, 01 November 2013 23:18

StefanoSpataro
Messages: 2736
Registered: June 2005
Location: Torino

first-grade participant

From: 2.235.190*

The Geant3 message is normal, since we use geane which is based on geant3. This is independent from the simulation, then also if you use geant4 it is fine.
I have run a g4 simulation and I cannot see problems with the reco. Are you sure you did not mess something in your macros?
Could you please upload your macros, modified so that so that one can reproduce your problem?

Report message to a moderator

[Message index]

		Reco error at Geant4 simulation By: donghee on Thu, 31 October 2013 11:07
		Re: Reco error at Geant4 simulation By: StefanoSpataro on Fri, 01 November 2013 23:18
		Re: Reco error at Geant4 simulation By: donghee on Sun, 03 November 2013 17:00
		Re: Reco error at Geant4 simulation By: StefanoSpataro on Sun, 03 November 2013 18:35
		Re: Reco error at Geant4 simulation By: donghee on Sun, 03 November 2013 21:17
		Re: Reco error at Geant4 simulation By: StefanoSpataro on Sun, 03 November 2013 21:20

Previous Topic:	G4 simulation: No MCPoint where one should be...
Next Topic:	MC true match with geant4

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun May 11 14:57:37 CEST 2025

Total time taken to generate the page: 0.00704 seconds