GSI Forum: General » Help in Creating a new diamond detector for Pid

Home » PANDA » PandaRoot » General » Help in Creating a new diamond detector for Pid

Show: Today's Messages :: Polls :: Message Navigator

Re: Help in Creating a new diamond detector for Pid [message #14997 is a reply to message #14989]

Tue, 23 July 2013 09:31

Shyam Kumar
Messages: 78
Registered: September 2012
Location: Mumbai, Maharashtra India

continuous participant

From: 103.21.127*

Hi
If I want to plot any two things in pid by using the below expression then what should I write in place of MCTrack.fMotherID!=-1.

cbmsim.Draw("MCTrack.fStartX:MCTrack.fStartY>>aa(200,-200,200,200,-200,200) ","MCTrack.fMotherID!=-1","colz“)

Report message to a moderator

[Message index]

		Help in Creating a new diamond detector for Pid By: Shyam Kumar on Sun, 21 July 2013 08:19
		Re: Help in Creating a new diamond detector for Pid By: StefanoSpataro on Sun, 21 July 2013 12:06
		Re: Help in Creating a new diamond detector for Pid By: Shyam Kumar on Sun, 21 July 2013 14:03
		Re: Help in Creating a new diamond detector for Pid By: Shyam Kumar on Tue, 23 July 2013 09:31
		Re: Help in Creating a new diamond detector for Pid By: StefanoSpataro on Tue, 23 July 2013 09:41

Previous Topic:	Problem in creating geometry from root file
Next Topic:	CUDA from PandaRoot

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Jun 02 12:52:13 CEST 2026

Total time taken to generate the page: 0.00821 seconds