GSI Forum: General » simulation of specific event number

Home » PANDA » PandaRoot » General » simulation of specific event number

Show: Today's Messages :: Polls :: Message Navigator

simulation of specific event number [message #14206]

Wed, 14 November 2012 09:47

Stefan Pflueger
Messages: 99
Registered: February 2012

continuous participant

From: *kph.uni-mainz.de

Hello everyone,

I wanted to simulate only one specific event with a lot of additional information for debugging reasons. For this I have a standalone evt gen file that I pipe through the pandaroot simulation via the DPM standalone interface. Within my macros I specify FairRunAna to run from Event 151 to 151 via FairRunAna->Run(151,151). This seems to work for all stages of the reco chain except the geant-simulation part (first part). Here he always starts at event 0 and stops at my specified event number. Is this a problem because I'm using a standalone event generator input file?

Best regards,

Stefan

Report message to a moderator

[Message index]

		simulation of specific event number By: Stefan Pflueger on Wed, 14 November 2012 09:47
		Re: simulation of specific event number By: StefanoSpataro on Wed, 14 November 2012 09:51
		Re: simulation of specific event number By: Stefan Pflueger on Wed, 14 November 2012 09:59

Previous Topic:	[SOLVED] subclipse in eclipse (ubuntu 12.04 64 bit)
Next Topic:	Retrieve parameters from all.par in simulation.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu May 15 07:21:36 CEST 2025

Total time taken to generate the page: 0.00470 seconds