GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » PANDA » PandaRoot » General » Digitization and Reconstruction in Fairroot to new detectors
Re: Digitization and Reconstruction in Fairroot to new detectors [message #13675 is a reply to message #13674] Wed, 27 June 2012 19:53 Go to previous messageGo to previous message
Raghav Kunnawalkam is currently offline  Raghav Kunnawalkam
Messages: 63
Registered: February 2012
Location: Stony Brook, New York
continuous participant
 From: *physics.sunysb.edu
Hi Stefano

Ok, so the hit producer calculates the hit for my detector and converts it into actual data based on the geometry defined in emcstructure.cxx. So if i just create these classes and also the ones they depend on, then i should be good to do some digi right? is this what Florian ment by doing simple smearing, or is it something else.

I also want to know what the nonuniformityfile is. In the beginning of emchitproducer, you create a constructor with that particular file in it /input/EmcDigiNoniformitypars.root

also is there a macro available that utilizes these classes to create the digi file?

Thanks a lot
Cheers
Raghav

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: switching off the information output
Next Topic: Cherenkov photons. Accuracy problem with Geant3
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun Jun 08 05:47:27 CEST 2025

Total time taken to generate the page: 0.00658 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software