GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » Alice » Alice TRD chamber construction » Drift HV to Radiator connection
Re: Drift HV to Radiator connection [message #1325 is a reply to message #1324] Tue, 25 January 2005 18:19 Go to previous messageGo to previous message
Clemens Adler is currently offline  Clemens Adler
Messages: 42
Registered: March 2004
continuous participant
 From: dialin-145-254-225-113.arcor-ip.net
Hi Chilo,
the technicoll is only used to fix the wires on the winding frame between the time the winding has finished and until the wires are glued onto the chamber, therefore this glue will not go into the chamber, so I guess it should be OK. BTW this glue was a recommendation from the GSI Detektor Lab, as far as I know they used it all the time for this application. But I think it is unlikely that some of it will creep onto the wires and go into the chamber.

It's probably a good suggestion to put a recommendation into the testing manual to ground the radiator outer surface when applying high voltage. Just in case I'll inform the chamber builders that there might be some risk.

thanks,
Clemens

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Anode Wire Problem Summary and Conclusion
Next Topic: Chamber Construction Manual: new version
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Apr 09 06:17:58 CEST 2026

Total time taken to generate the page: 0.00897 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software