GSI Forum
GSI Helmholtzzentrum für Schwerionenforschung
Home » Alice » Alice TRD chamber construction » Drift HV to Radiator connection
Re: Drift HV to Radiator connection [message #1324 is a reply to message #1323] Tue, 25 January 2005 17:57 Go to previous messageGo to previous message
Chilo Garabatos is currently offline  Chilo Garabatos
Messages: 12
Registered: August 2004
Location: GSI
occasional visitor
 From: lxial22.gsi.de
Hi Clemens,

The only red glue we use is Technicoll 8266/67 which is used for glueing the wires onto the wiring frame. Is there a Problem with that?
I think probably yes. The 'slow curing' version of Technicol was tested with a mass chromatograph years ago; the result was 'bad'. I wouldn't put it in contact with the gas.

About the radiator outer surface being floating, I think what happens is the following: the chambers are tested here in a rather dry atmosphere, so if one puts -2000 V on the other side, the outer surface will tend to charge up with positive ions until it screens the drift field. It would only discharge when something connects it to ground. Do you think that a ground connection of this should be specified in the manual? This has saved our fingers.
Regards,
Chilo

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Anode Wire Problem Summary and Conclusion
Next Topic: Chamber Construction Manual: new version
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Aug 20 16:31:10 CEST 2026

Total time taken to generate the page: 0.00875 seconds
.:: Contact :: Home :: Legal Notice :: Data Protection Policy ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software