GSI Forum: Tracking » Kalman low efficiency

Home » PANDA » PandaRoot » Tracking » Kalman low efficiency

Show: Today's Messages :: Polls :: Message Navigator

Re: Kalman low efficiency [message #11955 is a reply to message #11954]

Thu, 02 June 2011 15:51

Susanna Costanza
Messages: 33
Registered: January 2008
Location: Pavia

continuous participant

From: *13-87-r.retail.telecomitalia.it

Hi,
I had a look into the code.
The PndTrack flag can be filled both in PndRecoKalmanFit and in PndGenfitAdapters, with the following values:
i) -10 if pz=1e-9
ii) -2 if the conversion from GenfitTrack to PndTrack has failed
iii) -1 if the the number of degrees of freedom (NDF) = 0
iv) 1 if NDF != 0

Concerning fStatusFlag, it's a data member of GFAbsTrackRep. I see that in GFKalman it is set to 1 if you catch an exception in processHits(); then there is a continue and you go to the next rep.

So if I understand correctly, the values of these two flags do not seem to be related. Or am I wrong?

Susanna

Report message to a moderator

[Message index]

		Kalman low efficiency By: Susanna Costanza on Thu, 02 June 2011 12:04
		Re: Kalman low efficiency By: Anonymous Poster on Thu, 02 June 2011 12:19
		Re: Kalman low efficiency By: Susanna Costanza on Thu, 02 June 2011 12:31
		Re: Kalman low efficiency By: Anonymous Poster on Thu, 02 June 2011 12:33
		Re: Kalman low efficiency By: Susanna Costanza on Thu, 02 June 2011 13:07
		Re: Kalman low efficiency By: Anonymous Poster on Thu, 02 June 2011 13:10
		Re: Kalman low efficiency By: Susanna Costanza on Thu, 02 June 2011 15:51
		Re: Kalman low efficiency By: StefanoSpataro on Thu, 02 June 2011 16:14
		Re: Kalman low efficiency By: Anonymous Poster on Thu, 02 June 2011 17:28
		Re: Kalman low efficiency By: Susanna Costanza on Thu, 02 June 2011 18:19
		Re: Kalman low efficiency By: Anonymous Poster on Thu, 02 June 2011 18:34
		Re: Kalman low efficiency By: Susanna Costanza on Mon, 06 June 2011 18:29
		Re: Kalman low efficiency By: Anonymous Poster on Mon, 13 June 2011 10:21
		Re: Kalman low efficiency By: Susanna Costanza on Tue, 14 June 2011 11:33
		Re: Kalman low efficiency By: Anonymous Poster on Mon, 20 June 2011 14:13
		Re: Kalman low efficiency By: Anonymous Poster on Thu, 30 June 2011 10:17
		Re: Kalman low efficiency By: Susanna Costanza on Thu, 30 June 2011 10:51
		Re: Kalman low efficiency By: Susanna Costanza on Wed, 06 July 2011 12:51

Previous Topic:	MC true matching to reconstucted one
Next Topic:	TPC signal data available on GRID

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 16 20:50:30 CEST 2026

Total time taken to generate the page: 0.00902 seconds